Especificações
Item
Dadas
Application
Vertical or Horizontal
Installation Mode
Add-on
Table diameter(mm)
Ø210
Inner diameter of mandrel sleeve(mm)
Ø40H7
Diameter of center through hole(mm)
Ø40
Center height (Vertical)(mm)
160
Table height (Horizontal)(mm)
152
Table T-slot width(mm)
12H7
Guide block width(mm)
18h7
Transmission Mechanisms
Worm & Worm Gear
Min. increment(deg.)
0.001
Indexing precision(sec.)
20
Repeatability(sec.)
6
Clamping system (MPa / kg/cm²)
Hydraulic (3.5 / 35)
Clamping torque(N.m / kgf · m)
540 / 55
Servo motor model(FANUC)(Straight shaft without key)
αiF8 / βis8
Servo motor model(MITSUBISHI)
HG - 54 / 104
Speed reduction ratio
1:90
Max. rotation rate of table(min-1)
44.4
Allowable inertia load capacity (vertical)(kg-m²)
0.63
Allowable workpiece load (Vertical)(kg)
75
Allowable workpiece load (with support table)(kg)
150
Allowable workpiece load (Horizontal)(kg)
150
Allowable thrust load (with rotary table clamping) F (N / kgf)
14225 / 1450
(Axial)＊1 Allowable thrust load (with rotary table clamping) FxL (N.m / kgf·m)
1079 / 110
(Radial)＊2 Allowable thrust load (with rotary table clamping) FxL (N.m / kgf·m)
304 / 31
Driving torque(N.m / kgf·m)
284 /29
Net weight ( sever motor excluded)(kg)
55
＊1
If a mechanical brake is not used, this value will correspond to the motor's holding torque.
＊2
The structural limit value, while the actual operating speed will vary depending on the motor.The structural limit value, while the actual operating speed will vary depending on the motor.
Dimensão
